Solar Cable Route Length Calculator
Route Length Calculator
Estimate total DC and AC cable quantities including contingency for procurement and BOQ. Adjust any input and the take-off updates live.
Inputs
Updates liveResults
LiveTotal cable route length (1.54 km)
10% contingency included
DC Cable
metres
AC Cable
metres
Total Cable
km
Cable Bill of Quantity
“IS 1554 Part 1:2000 — PVC insulated cables for working voltages up to and including 1100V. DC cables (EN 50618 / TÜV PV1-F) are solar-grade with UV-resistant sheath, rated for 1000V or 1500V DC.”
About the Cable Route Length
Cable route length calculation measures the actual cable run length between two points in a solar plant — accounting for horizontal distance, vertical rises, bends, and entry/exit loops — to accurately size cable cross-sections, estimate voltage drop, and budget cable quantities.
How to calculate it
- 1Measure straight horizontal distance between the two endpoints on the plant layout drawing.
- 2Add vertical rises: each metre of height change adds one metre of cable length.
- 3Add bend allowances: each 90° bend adds approximately 1–2 m to the effective route length.
- 4Add entry/exit loops at each end: 0.5–1 m per termination for strain relief and future maintenance.
- 5Add a 5–10% contingency for unforeseen route deviations.
- 6Total route length = Σ(horizontal + vertical + bends + loops) × 1.05–1.10.
Worked example
A DC cable from AJB to inverter room: horizontal distance 28 m, one 90° bend up a wall (2 m vertical rise + 1.5 m bend allowance), exit loop at AJB (0.5 m), entry loop at inverter (0.5 m). Subtotal = 32.5 m. With 10% contingency: 35.75 m → order 36 m per polarity (72 m total for + and −).
What you can calculate
- DC + AC routes
- 10–15% contingency
- Total m
- Cost estimate
Frequently asked questions
Why does cable length matter more than direct distance in solar plants?
Voltage drop is proportional to cable length — a longer actual route causes more resistive loss and lower inverter input voltage, both reducing yield. Cable sizing is also based on route length: a 25 m route vs a 15 m direct distance may require the next larger cable cross-section to stay within the 1% voltage drop limit. Accurate route lengths prevent under-sizing errors that are expensive to fix after installation.
How do I measure cable route length on a rooftop plant?
For rooftop plants, route length cannot be scaled from a 2D plan — it must account for the actual 3D path: across flat sections, down parapet walls, up risers, around obstacles. The best practice is to walk the route with a measuring wheel during site survey, or use a string/tape to trace the proposed path. Add 15% to measured rooftop routes (vs 5–10% for ground-mount) due to the higher frequency of obstacles.
Ready to build your solar project?
Get free quotes from verified EPCs and installers across India.
You might also need
Pedestal Height
Calculate front and rear pedestal heights for target module tilt on flat rooftops
OpenModule Layout Planner
Plan tables, rows and string configuration for a rooftop array
OpenSetback from Parapet
Calculate minimum module setback from parapet walls to avoid shading
OpenBallast Weight
Calculate ballast required to resist IS 875 Part 3 wind uplift without penetrations
OpenWind Load (Rooftop)
Calculate uplift and lateral wind forces on rooftop PV modules per IS 875 Part 3
OpenAnchor Bolt Sizing
Determine anchor bolt count, diameter, and embedment depth for structural loads
Open